Community Q&A
What are you stuck on?
Ask in your own words. Answers are written for Vectric software: Aspire and VCarve.
Community
Recent questions
What people asked lately. If you hit the same thing, open it and press Me too.
- AnsweredFrom the shopVCarve ProCNC router1 shop answer
Why is my bit digging into the wood on the 3D roughing pass?
A question we get a lot: the roughing pass on a 3D carve goes deeper than it should and gouges the model or the board around it.
Kinetic Carvingasked - AnsweredFrom the shopVCarve ProCNC router1 shop answer
Why is my bit cutting air, or cutting into my spoilboard?
A question we get a lot: the job runs, but every cut is too shallow or too deep, often by exactly the thickness of the board.
Kinetic Carvingasked - AnsweredFrom the shopVCarve ProCNC router1 shop answer
Can VCarve Pro open an Aspire file someone sent me?
A question we get a lot: someone shares a .crv3d file and VCarve Pro will not open it. Does it work the other way around?
Kinetic Carvingasked - AnsweredFrom the shopVCarve ProCNC router1 shop answer
Why does my V-carve inlay have gaps, or the plug won't seat?
A question we get a lot: the inlay plug bottoms out before it seats, or it fits tight in some letters and loose in others.
Kinetic Carvingasked - AnsweredFrom the shopVCarve ProCNC router1 shop answer
Why is my bit burning the wood, even when I slow down?
A question we get a lot: scorch marks in the corners or smoke during a carve, and slowing the feed only makes it worse.
Kinetic Carvingasked - AnsweredFrom the shopAspireCNC router1 shop answer
How do I get rid of ridges on my 3D finish pass?
A question we get a lot: a 3D carve comes off the machine with lines or a washboard pattern after the finish pass.
Kinetic Carvingasked